Posted on Monday Jun 30, 2014 at 9:10 AM
Kansas Basser,
Funny you asked about a picture. I had 2 Pics on my phone and just deleted them off 5 minutes ago. I could go take another, but I replaced by Bearings, Seal and Races yesterday. I went ahead and bought a Needle Adapter from O'Reilly's that comes to a tapered point which seemed like the most logical to use on my Spindle. After repacking bearings, etc, I put everything back together and was able to get grease to flow thru the center of the Spindle and push all the way to the front like its supposed too. It is a little hard for 1 person to apply pressure to the Needle and pump grease, so my Son helped me and it worked ok, except some grease did escape from the point of contact. The problem with the other type with the Needle that inserts into the hole would be that the Pin holding the Castle Nut on would stop the Needle from entering far enough. Anyway, I believe I found the right method. Any more thoughts??????
Thanks for the help!
|