Trim
Reply    
    
Previous Page    Page
select
of 1    Next Page
Posted on Saturday Jul 16, 2011 at 10:37 AM  
My trim will not go up fast if at all and it drops as soon as it goes up any. It seems one piston is much lower and the end cap seems to be slighty seperated. There is also rubber that looks like the piston tore it out of the cylinder. Is this a seal problem or the whole piston shot? Is this something I can fix or what would it cost? It's a 2003 yamaha vmax 200hp
Posted on Saturday Jul 16, 2011 at 10:03 PM  
Sounds like a seal. If you have a spanner wrench then you can fix. Some of them are tight to get to and might take a knuckle or two.
Posted on Saturday Jul 16, 2011 at 10:05 PM  
Change the seal flush the system and bleed it.
Posted on Sunday Jul 17, 2011 at 3:08 PM  
One of the bottom o rings and Teflon broke. Where is the best place to get the ring and seals? Figured I might as well replace them all since I'm in there
Posted on Sunday Jul 17, 2011 at 8:55 PM  
Me.... No online surf eBay
Reply    
    
Previous Page    Page
select
of 1    Next Page